…The semi was headed west when its raised bed slammed into the overhead sign near mile marker 200 as it approached the I-64/I-295 split.
Virginia State Police said the crash happened shortly after 9:30 a.m.
“The cab continued on and then stopped, obviously, because it had separated from the bed of the tractor-trailer,” Matt Demlein, a spokesperson for Virginia State Police, said. “We’re still investigating as to what led up to it actually hitting the sign. It was empty at the time.”
Troopers do not know why the bed was raised or how long it was up before the crash. But officials said the truck had stopped at a weigh station about a mile earlier, which is equipped with cameras…
Aren’t most trucks equipped with interlocks that prevent travelling at speed when the bed isn’t fully lowered?
No. Every couple years we get inquiries for it, but they don’t want to pay to have it installed.
Probably one complication is that the trucks need to be able to drive while the bed is up in normal operation. They have to move forward while dumping to spread the load.
Not just to spread it, they have to scooch a bit to let the material fall. The tightest end dump pile is still a fat line.
This is an amusing sentence out of context.
“Shit, that’s just Tuesday night around here”
At speed?
Therein lies the complication.
Nah, all trucks transmit their speed on the CAN network. It’s very simple to implement.
Sounds like you found your million dollar idea! Now its as easy as cashing all your cheques! Congratulations!
It is easy to implement. the challenge is convicing the bean counters providing a safety feature for the rare instance of the driver being a dumbass is worth the cost.
Not just that, but you need a standard to communicate it truck to trailer and retrofit it so it all plays nice.
Could be done on a dump truck though if there is a way to set a separate governor in the computer that gets enabled by the bed up light somehow.
All trucks support J1939 TSC1 message.
And does the pigtail to the trailer support it?
Usually you can access it through the obd2 port.
But realistically, there’s no reason why you can’t design the hydraulics in a way that the cylinder is always leaking through an orifice and the dump trailer is constantly slowly lowering itself unless you are actively holding the Up button. There’s never a case where a truck needs to hold it’s dump up in the air for long periods of time.
That is a hilarious and practical suggestion. It would confuse and irritate so many people, even though it’s no issue like you say.
He might not have been fully up to speed yet. This sign is just past a weigh station (I’ve driven this stretch many, many times), and VDOT said he had just gone through the station. Though that doesn’t answer why the bed was up. Could have bumped the switch?
:::Edit to strike through this nonsense:::I am leaning toward the other explanation of drive shaft breaking and pole vaulting the trailer into the sign.
deleted by creator
A very excellent point. I should have realized.
Even if it did, it would not pole vault. Mythbusters tried polevaulting a car, it barely lifts the rear end off the ground. The drive shaft is just a hollow tube that bends instead of tranfering all the enegry to the vehicle.